About this
Tool
Legend

3D Profiling Calculator

Imperial
Metric
Tool Description Enter Tool Specs here.
Useful for later calculations.
Enter Tool Specs here. Useful for later calculations.
Diameter (D):
 
Overall Length (OAL):
 
Length Below Shank (LBS):
 
# Flutes (z):
 
Length of Cut (LOC):
 
Helix Angle (ω):
 [deg]
Effective Tool Diameter Provide Diameter above for best results. [Help]
Provide Diameter above for best results.

 
 
Tool Tilt Angle (β):
 [deg]
Effective Tool Diameter (Deff):
 
Cutting Parameters Provide Diameter, Number of Flutes, and Ap above for best results.
Provide Diameter, Number of Flutes, and Ap above
for best results.

 
Chip Load (fz):
 

 
Adjusted Chip Load (fz'):
 
Adjusted Feed (f'):
 
Cutting Conditions Provide Diameter above for best results. [Help]
Provide Diameter above for best results.

 

 
Lead Angle (ψ):
 [deg]
Surface Finish Provide Helix Angle above for best results. [Help]
Provide Helix Angle above for best results.
 
DataFlute
These calculations are based upon theoretical values and are intended for planning purposes, actual results may vary.
Berkshire Precision Tool, LLC is not responsible for variations between predicted and observed performance.